Why does my shower leaks - and what to do was

Why does my shower leaks and what to do. Have you ever had a shower pan that is not sealed? This can be a nightmare for property owners! This may be the walls and floors and cause mold and fungus that can ruin a risk to health.

Some basic information:

Some old houses were built 20 years ago or more was a "settlement" shower trays. Were a kind of tar paper. When a shower tray full of water from a loss ofArticles of cement in the brick and then wet the shower pan, worsened after a while ', and the pot was no longer a receptor for the water leakage to hold. The water simply ran out of the ground and on the bathroom floor.

Newer bathroom use a vinyl shower pan material that does not deteriorate. So, unless there is a big hole in the vinyl pan construction nails or screws in the pan, which has the task of water from a drain by flooding your bathroom shower floor is maintained. So withVinyl new pots, or if you have soldered copper pot, you must maintain a large receptor that is losing water.

But ... Even with a good shower pan, you may still have problems: if the cement is in the shower pan is completely saturated place for water to go except through the capillary wall and down the toilet. If sub cementatious walls, not bad, if corrected in time. The walls are dry and loose tiles and marble, it is possiblereplaced.
If it is a green board (drywall on your walls), if not set in red and
Then it's time for a fundamental review.

Why leave shower?

The most common reason for a shower floor that leaks is a faulty system:

1. What, could not cut the tile or marble against the wall.

2. Areas of low cement works in the context of the tile. The water is depressed and not
flow to drain. For some materials may be in the migrationPan.

3. Cut tile itself can not establish that the flight-crack, and open an entrance for water.

4. The most common reason is the shower floor was installed after the walls finally!
In this case, if the shower will change from expansion and contraction due to
Temperature changes, or to estimate the house. A crack or separation is made between the
finished shower wall and the finish floor shower. "This is the entrance of water."
The shower floor must be constructed, the otherthe contrary, that the material wall Countries
On the top of the finished product shower floor, forming a water barrier and is much more difficult for the water inside there is a second series of holes in the creek where the water is going to happen if the concrete under the wet floor yes, but in my experience rarely works.

5. Sometimes it is not to let the floor of the shower water, the conversion is leaking behind the wall. This is easy to determine.Take from the tap handles and eschucheon(Cover plate) Put the handles and turn on the water. Look inside the open hole with a flashlight, if necessary, and see if it is water leaking from a change once in a while ', this is the problem. If you need a new divereter.

Over the next article: How do you keep from leaking shower and preventive maintenance

patio heaters Construction Models : All Toys Photo Viewers